![]() ![]() R2(config-router)#neighbor 13.0.0.1 update-source loopback 0 *Jan 23 13:47:51.843: %BGP_SESSION-5-ADJCHANGE: neighbor 11.0.0.1 IPv4 Unicast topology base removed from session RR client config change R2(config-router)#neighbor 11.0.0.1 route-reflector-client R2(config-router)#neighbor 11.0.0.1 update-source loopback 0 R1(config-router)# neighbor 14.0.0.1 update-source loopback 0 R1(config-router)#neighbor 12.0.0.1 update-source loopback 0 H Address Interface Hold Uptime SRTT RTO Q Seq Interface IP-Address OK? Method Status ProtocolįastEthernet0/0 40.1.1.1 YES manual up upįastEthernet0/0 20.1.1.1 YES manual up upįastEthernet0/0 30.1.1.1 YES manual up up ![]() configure router 2 - 4 RR server and router 1 - 3 client.Configure EIGRP to provide the reachability between BGP speakers (peer).Configure the topology as er the diagram and assign the IP address.In our case we have two RR servers and it will establish neighbor with other servers and clients. If a route reflector (RR) receives a route with a cluster-list attribute containing its cluster-ID, the route is discarded.If a router receives an IBGP route with the originate-id attribute set to its own router-ID, the route is discarded.We have already learned what route reflector is and why we use route reflector. In this section we will see the configuration of two RR servers and will learn about deep RR behavior.Ī route reflector is a BGP router that is allowed to ignore the IBGP loop avoidance rule, such as is allowed to advertise updates received from an IBGP peer to another IBGP peer under specific conditions. BGP route reflector (RR) configuration of two RR servers ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |